board_configuration.cpp

Go to the documentation of this file.

/**
 * @file board_configuration.cpp
 *
 *
 * See https://rusefi.com/s/XXX
 *
 * @author andreika <prometheus.pcb@gmail.com>
 * @author Andrey Belomutskiy, (c) 2012-2020
 */
 
#include "pch.h"
#include "hellen_meta.h"
#include "defaults.h"
#include "board_overrides.h"
 
static void setInjectorPins() {
    engineConfiguration->injectionPins[0] = Gpio::H144_LS_1;
    engineConfiguration->injectionPins[1] = Gpio::H144_LS_2;
    engineConfiguration->injectionPins[2] = Gpio::H144_LS_3;
    engineConfiguration->injectionPins[3] = Gpio::H144_LS_4;
    engineConfiguration->injectionPins[4] = Gpio::H144_LS_5;
    engineConfiguration->injectionPins[5] = Gpio::H144_LS_6;
}
 
static void setIgnitionPins() {
    engineConfiguration->ignitionPins[0] = Gpio::H144_IGN_1;
    engineConfiguration->ignitionPins[1] = Gpio::H144_IGN_2;
    engineConfiguration->ignitionPins[2] = Gpio::H144_IGN_3;
    engineConfiguration->ignitionPins[3] = Gpio::H144_IGN_4;
    engineConfiguration->ignitionPins[4] = Gpio::H144_IGN_5;
    engineConfiguration->ignitionPins[5] = Gpio::H144_IGN_6;
}
 
static void setupDefaultSensorInputs() {
    // trigger inputs
    engineConfiguration->triggerInputPins[0] = Gpio::H144_IN_CRANK;
    engineConfiguration->triggerInputPins[1] = Gpio::Unassigned;
    // Direct hall-only cam input
    engineConfiguration->camInputs[0] = Gpio::H144_IN_CAM;
 
    engineConfiguration->tps1_1AdcChannel = H144_IN_TPS;
    engineConfiguration->tps1_2AdcChannel = H144_IN_AUX1;
 
    setPPSInputs(EFI_ADC_3, EFI_ADC_14);
    engineConfiguration->mafAdcChannel = EFI_ADC_10;
    engineConfiguration->map.sensor.hwChannel = EFI_ADC_11;
 
    engineConfiguration->clt.adcChannel = H144_IN_CLT;
 
    engineConfiguration->iat.adcChannel = H144_IN_IAT;
}
 
 
 
static void hellen88_boardConfigOverrides() {
    setHellenVbatt();
 
    // hellen88bmw uses L6205PD
    engineConfiguration->etbIo[0].directionPin1 = Gpio::H144_OUT_PWM2; // ETB+
    engineConfiguration->etbIo[0].directionPin2 = Gpio::H144_OUT_PWM3; // ETB-
    engineConfiguration->etbIo[0].controlPin = Gpio::H144_OUT_PWM1; // ETB_EN
    engineConfiguration->etb_use_two_wires = true;
 
    setHellenSdCardSpi3();
 
    engineConfiguration->clt.config.bias_resistor = 2700;
    engineConfiguration->iat.config.bias_resistor = 2700;
}
 
/**
 * @brief   Board-specific configuration defaults.
 *
 
 *
 
 */
static void hellen88_boardDefaultConfiguration() {
    setInjectorPins();
    setIgnitionPins();
 
    engineConfiguration->displayLogicLevelsInEngineSniffer = true;
 
    engineConfiguration->enableSoftwareKnock = true;
    engineConfiguration->canNbcType = CAN_BUS_NISSAN_VQ;
 
    setHellenCan();
 
    engineConfiguration->fuelPumpPin = Gpio::D12;   // OUT_IO9 // 113 Fuel Pump Relay
    engineConfiguration->idle.solenoidPin = Gpio::H144_OUT_PWM5;
//  engineConfiguration->fanPin = Gpio::D12;    // OUT_PWM8
    engineConfiguration->mainRelayPin = Gpio::H144_OUT_IO3; // pin: 111a
    engineConfiguration->tachOutputPin = Gpio::H144_OUT_PWM7;
 
    // "required" hardware is done - set some reasonable defaults
    setupDefaultSensorInputs();
 
    // Some sensible defaults for other options
    setCrankOperationMode();
 
    setAlgorithm(engine_load_mode_e::LM_SPEED_DENSITY);
 
    // Bosch VQ40 VR56 VK56 0280158007
    engineConfiguration->injector.flow = 296.2;
 
    strcpy(engineConfiguration->engineMake, ENGINE_MAKE_BMW);
 
    engineConfiguration->ignitionMode = IM_INDIVIDUAL_COILS; // IM_WASTED_SPARK
 
    engineConfiguration->luaOutputPins[0] = Gpio::G5; // 104 ETB Relay
 
    setPPSCalibration(0.75, 4.45, 0.43, 2.20);
 
    // this calibration reminds me of VAG just flipped?
    engineConfiguration->tpsMin = 100;
    engineConfiguration->tpsMax = 889;
 
    engineConfiguration->tps1SecondaryMin = 891;
    engineConfiguration->tps1SecondaryMax = 102;
    hellenWbo();
}
 
void setup_custom_board_overrides() {
    custom_board_DefaultConfiguration = hellen88_boardDefaultConfiguration;
    custom_board_ConfigOverrides = hellen88_boardConfigOverrides;
}